A Canon printer. Not just a simple one, but a big (wide) one with real ink tanks, about 20 years ago.
Under Linux, I could only access basic printing services with that, and this only by using a default driver not made by Canon that happened to work. So I contacted Canon to get a proper user manual to create a proper device driver for this (something I could have done without problems), and basically got the answer that they would not support this, as “open source is theft of intellectual property”. They also had some very choice words about Linux in general.
I assumed I just got an asshole on the phone, so when I attended Cebit a short time later (back then the biggest trade fair in Europe for things like that), I went to the Canon booth, explained my issue, and basically got the same reply. So I sold the Canon printer and bought an HP one. At least HP supported Linux and supplied working drivers. Sadly, they have really gone down the drain since that, so the next printer will be a different brand again…
Well, the question for me back then was printing wide, so the selection was quite limited from the start. And laser was completely out of the equation, as anything printing wider than 21cm was industrial (size of a bus and price of a house) back then.
Ink stinks, but I’ll condone the toner. Inkjets are so unreliable compared to lasers. Good luck, but I worry you’re stacking the deck against yourself a bit with the ink and would hate to see you lose here.
A Canon printer. Not just a simple one, but a big (wide) one with real ink tanks, about 20 years ago.
Under Linux, I could only access basic printing services with that, and this only by using a default driver not made by Canon that happened to work. So I contacted Canon to get a proper user manual to create a proper device driver for this (something I could have done without problems), and basically got the answer that they would not support this, as “open source is theft of intellectual property”. They also had some very choice words about Linux in general.
I assumed I just got an asshole on the phone, so when I attended Cebit a short time later (back then the biggest trade fair in Europe for things like that), I went to the Canon booth, explained my issue, and basically got the same reply. So I sold the Canon printer and bought an HP one. At least HP supported Linux and supplied working drivers. Sadly, they have really gone down the drain since that, so the next printer will be a different brand again…
Try brother. They’re usually quite good, though I’ve only had their laser printers.
It will probably be either a Brother Inkbenefit or an Epson Ecotank model.
My last Epson is a model from 2009 and still somehow works perfectly. Every Canon I’ve owned was garbage.
Well, the question for me back then was printing wide, so the selection was quite limited from the start. And laser was completely out of the equation, as anything printing wider than 21cm was industrial (size of a bus and price of a house) back then.
Ink stinks, but I’ll condone the toner. Inkjets are so unreliable compared to lasers. Good luck, but I worry you’re stacking the deck against yourself a bit with the ink and would hate to see you lose here.
Don’t worry, I consider lasers, too.
I got an HP printer and it’s prints reliably when connected via USB but that’s about it.