Urgh, I relate to the majority of comments in this thread and I think it’s time I schedule that colonoscopy…
Back in those days, DJ played Spectrum game on the air. I taped the game on Cassette and after that played the game. Don’t remember which game was.
what
Computer code was translated into audio. That audio was then broadcast over regular radio used for music and news. If you had a cassette recorder and a blank cassette, you could simply record the sound coming out of the speakers of a radio. You then put this recorded cassette into a cassette tape player connected by a wire to your computer so the computer would hear the cassette play. You run a special command on the computer so it starts listening, you press play on the tape and the computer will translate the recorded audio back to computer code. You could then run that program.
If you’re familiar with the 56k modem connection song, that’s a similar principle. The telephone line is analog but digital content can be encoded in analog using a DAC, at which point it’s can be interpreted as an audio signal and played through a speaker.
The sound itself was just data (training patterns, not the actual data of interest, that gets transmitted after the “song”) being encoded at a faster and faster rate, and it would select the fastest speed it could transmit data at reliably along the line. The “song” would progress further the higher the speed it could communicate reliably with the other side, or it might go back and repeat a section because it could negotiate phase (and other parameters) as well as bitrate, which might improve the line reliability, but it still needed to see that test pattern come through cleanly before it would accept a rate.
From your choice of words I see you are/were a Commodore user
Guilty as charged! My C64 is sitting close to me right now. I half considered putting PRESS PLAY ON TAPE in caps just to drive the point home.
We used to load computer games from a cassette tape. You could copy games with a back 2 back tape deck / ghetto blaster.
If you played the screechy computer noises over the airwaves someone could record the game off the radio.
N.B. I’m not OP
My friend had a VIC-20 but without the tape drive (which was optional). We would have to type a game (written in BASIC) into the computer before we could play it. My friend would try and leave the machine on as long as possible so we didn’t have to keep retyping it, but his mom always turned it off at night. For whatever it’s worth, that kind of shit really teaches you accuracy.
We would get really deep into a game of Zork, and because there as no savepoints, we just turned off the monitor and came back to it later. Leaving our C64 on that long may have contributed to the power supply dying prematurely. My mom was also using the C64 to write her master’s thesis. Sorry mom.
Yes, power supply issues were a thing with C64’s. Our dad had to send ours for repair twice because we kept leaving the thing on for Zork.
That’s metal as fuck
I came across a nice little preservation story that I couldn’t resist writing about!
Back around 1980, Canadian university student Steven McDowell created an air traffic control simulation for the Commodore SuperPET, written in Waterloo microAPL. He thought the program had been lost forever, until more than forty years later, when he discovered three and a half pages of its original source code printed on old dot-matrix paper. Instead of just archiving the listing, he painstakingly typed it back into an emulator and spent around 40 hours debugging and reconstructing the software until the little aircraft were flying again!
Nice example of how easily early computing history could disappear, and how something as ordinary as a few surviving sheets of paper can bring it back. I’ve written a tiny little article about McDowell, the unusual SuperPET and the recovery of his program. Hope you enjoy it!
How could it fit in 3.5 pages?
What he found wasn’t the complete game/project. He was lucky to have found even that much, but he had to recreate the rest to release it now
Apl uses a lot of math notation, so it can be very succinct
https://en.wikipedia.org/wiki/APL_(programming_language)?wprov=sfla1
That’s so cool.
There was an Apple ][ magazine that printed a program in hex each month. Pages and pages to type in. Get it all right and you had yourself a new program. Taught you patience if nothing else.
Oh ya. Waiting for the school to open at 7am. We reserved time slots to use the Apple 2 ( the only school in the city to have a computer ) to type in those programs. First it was tape, then floppies.
I’ll be retiring I.T. in a couple of years LOL
My 9th grade programming class had a bunch of Apple IIe computers. They were great for the time, I guess. I spent most of the semester recreating the Battlezone arcade game on it, while the rest of the class struggled to get a key-driven menu working.
I did that a lot… and I printed my code on sheets of paper; I just feel weird reading OP article.
Edit ( because I also printed out sheets of paper with my programs from the commodore64).
Typing code from PC Magazine was how I often got my VIC-20 working.
Same but with a Timex Sinclair 1000 and it’s respective magazine. 2k memory but I had the 16k upgrade module, and of course the cassette tape deck to save everything on…
My first computer, and it was an antique by the time I had it. The disks were like the size of a dinner plate.









